I've got a Hardinge 1986 SB-3 GN and it goes into emergency stop after about an hour of running. No codes or anything on the display. It seems like something is over heating. I do have an LED that comes on on the spindle drive, but have no way to diagnose. Description above the LED: NETZ UEBERM. Any Ideas greatly appreciated!
I've attached a picture of the LED.
Results 1 to 1 of 1
-
04-23-2015, 02:52 PM #1
Registered
- Join Date
- Jan 2009
- Posts
- 3
Hardinge SB-3 GN goes into E-Stop after and hour of running with no alarm number
Reply With QuoteSimilar Threads
-
Haas Mill Stop No Alarm Spindle running
By MachinistDan in forum Haas MillsReplies: 5Last Post: 10-06-2014, 12:58 PM -
Artisan software running my Hardinge HCNC lathe
By JimFerguson in forum Hardinge LathesReplies: 0Last Post: 08-14-2014, 07:52 PM -
Hardinge GS 250 on Stop
By Brudy in forum Hardinge LathesReplies: 0Last Post: 05-02-2013, 03:42 PM -
running dnc mode on hardinge
By marcojr in forum Bridgeport / Hardinge MillsReplies: 0Last Post: 09-19-2007, 07:26 PM -
Running a set number of parts?
By Shizzlemah in forum Centroid CNC Control ProductsReplies: 2Last Post: 05-03-2005, 12:47 AM
Tags for this Thread
Posting Permissions
