586,103 active members*
3,309 visitors online*
Register for free
Login

Thread: G code SolidCam problem

Results 1 to 4 of 4
  1. 07-23-2012, 06:25 AM #1
    zambrano
    zambrano is offline Registered
    Join Date
    Mar 2008
    Posts
    25

    G code SolidCam problem

    I learn SolidCam to generate g codes of turn operations, however solidcam always generate g codes with double diameter of the design.

    Any know the reason of this problem.

    Regards

    Zambrano
    Reply With Quote Reply With Quote
  2. 07-23-2012, 08:06 AM #2
    Brakeman Bob
    Brakeman Bob is offline Registered
    Join Date
    Oct 2007
    Posts
    499
    It is the way your post processor is set up. Some lathe controls are programmed using the diameter value rather than the radius and it appears your post set up for that. Talk to your reseller or have a go at editing your GPP file.
    Reply With Quote Reply With Quote
  3. 07-30-2012, 07:36 PM #3
    zambrano
    zambrano is offline Registered
    Join Date
    Mar 2008
    Posts
    25
    Than You Brakeman. I change X mode in Mach3, Config-Ports and Pins-Turn Options.
    Regards
    Mike
    Reply With Quote Reply With Quote
  4. 11-21-2013, 11:55 PM #4
    solidcamx
    solidcamx is offline Registered
    Join Date
    Feb 2011
    Posts
    252
    I can write a postprocessor for you. [email protected]
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Is there a way to generate CL code in Solidcam
    By manussim in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 6
    Last Post: 02-02-2021, 07:02 PM
  2. Fanuc blueprint in solidcam and repeating code
    By pinguS in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 12
    Last Post: 10-11-2014, 03:48 PM
  3. SolidCAM - g-code export fail
    By mr chris in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 6
    Last Post: 06-01-2010, 07:49 AM
  4. SolidCam Radius Problem
    By CNCOX in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 4
    Last Post: 11-10-2009, 05:37 AM
  5. Lathe g-code output from SolidCAM
    By BSF in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 2
    Last Post: 07-06-2009, 08:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules