Hi everyone, my problem is that i have a hydroflow multifeeder barfeed connected to the hurco tm8. The problem is have i put to many m codes in to the program or not enough or even the wrong ones.
I have a bar in the chuck, the machine tells me that the last component is giong to be machined out of the remaining bar. the bar feeder ram rod comes down the pipe and ejects the bar end. The cams go round to load the bar on to the rail the carrage loads the bar into the machine pipe (spindle) the carrage retracts, the machine screen shows a warning like time out. what should happen after the bar is fed in to the pipe is that the ram rod should push the bar up to the machine stop, but for some reason it doesn't. any suggestions.
the m code i'm using is m20 m22 m21
thanks for looking