I searched the Forum for a better place to put this, but I could not. So excuse me if this is in the wrong place.
My Father was building a CNC machine for the last half dozen years, but he passed before he could completly finish it. He did get to see it run, but it only made a few cuts. I really want to make it function, but I need some info. In a few of the books he left with the machine, I noticed there were a few notes taken from this site. I think he was a member, but I'm not 100% sure when or how long it has been since he posted. I'm not even sure what his screen name was, but I'm hoping to get some help from a Admin. I'm just hoping to see his older posts to try to get a idea what went into his creation. Thanks for any help that can be offered.