:boxing:run-a-way machine, no controll on feed rate, 20" ipm same as .001 ipm, feed rate same as rapid. NEED HELP, NEED HELP
:boxing:run-a-way machine, no controll on feed rate, 20" ipm same as .001 ipm, feed rate same as rapid. NEED HELP, NEED HELP
Same problem on all axis?
the feed problem seem to be in x & y axes only. Z axes feeds seem to be ok
the mill is a fadal 4020, 1996
The first test is probably to swap axis boards around and see if the problem follows the boards. If not, then the main board, eprom, or CPU is likely bad. Tech support at MAG (Fadal) was always helpful to me for talking through trouble shooting. You may want to call them.