[sthefciu]

Hi,

I have a problem with the laser of the type HX made in China. After finishing work, the machine does not respond to any buttons, I can not delete files from the memory, because the machine does not respond to anything .. I have mpc6515, prog laser cut 5.3. What is the cause? I am writing from Poland , please help ..

[cinematic2]

Zacznij od wgrania nowego firmware. Jak to nie pomoże to wymień płytę główną.

[Rodney Gold]

Translate for those of us that don't speak siberian turkish

[Exsecratio]

Cine is saying

Start by trying to update the firmware followed by a new mainboard if required although my command of Polish is a little rusty.

best wishes

Dave

[sthefciu]

When sending the firmware "download cfg" laser also hangs. Communication card was replaced two months ago. i have a two versions of Lasercut on my computer 5.1 and 5.3 Maybe this is the cause?

[cinematic2]

"download cfg" do not change firmware. Only settings.


How to download the MPC6515 firmware:
====================================

1) Copy the two files 65154120.FMW and 65154001.HDW to the root of a USB
Mass Storage Device. The Device must be formatted as FAT16. It's bettter
to remove any other files from the root of the Storage Device.

2) Power on, then the indicator D1 in the mianboard of MPC6515 will flash
two times instantly.

3) Insert the USB Mass Storage Device into MPC6515.

4) The indicator D1 will light for 2 to 10 seconds depend on the size
of the firmware files. It means downloading. Don't remove the USB Mass
Storage Device.

5) Once the indicator D1 flash frequently, the downloading is end.

6) Remove the USB Mass Storage Device, and the MPC6515 will load the new
firmaware. Repeat the steps if the MPC6515 can not work after downloading.
If still abnormity, please contact with your provider.

Notice:

1) This firmware can only be used to MPC6515 controller.

======================
Step Servo (ChengDu) Co., Ltd.

[sthefciu]

Okej, wszystko wiem... Oprócz jednego Te dwa pliki znajdę gdzieś tu w 'download', tak? Pózniej wgrać ustawienia "dowload cfg" i laser powinien chodzic?

[cinematic2]

gdzieś tu w 'download',

Nie wiem gdzie to jest gdzieś tu w 'download' :-(

[a_laserguy]

If you are saying the laser finishes a job engraving or cutting. Then you cannot move the laser head or anything else from control panel of laser? When job finishes you must press ESC on control panel.


Po włączeniu komputera wszystko działa normalnie? Podczas uruchamiania cięcia lub grawerowaniem następnie, po zakończeniu zadania następnie użytkownik nie może przenieść laserowa głowica lub czegokolwiek innego panelu sterowania? jest to normalne, gdy zadanie zostało zakończone. Naciśnij klawisz ESC na panelu sterowania a następnie wszystko wraca do normalnego.