[kadeR]

Hi, i recently bought an chinese laser cutter 1390 with an RZNC-D5416/3/ L13.

Is there some way to verify the cutting/engraving time to give budgets without running the program in the machine with the laser off?

Thanks

[Exsecratio]

Lasercut software has a "Timer" function but to be honest it's a best guess (and not a very accurate one)

best wishes

Dave

[Asynchronism]

Lasercut software has a "Timer" function but to be honest it's a best guess (and not a very accurate one)

best wishes

Dave

I haven't tried it for engraving, but it's been spot-on for all of my cutting projects... even the 2-3 hour ones. I was actually surprised it works as well as it does.

Engraving might be another issue, that's probably something you'll be able to estimate just by looking at after a few runs.

(the other) Dave

[kadeR]

i dont know if my machine works with lasercut software... we only use an add-on in coreldraw or autocad.

thanks

[G.Weike-Abby]

what software with the machine when you get it ? Or your machine is PCI type?

[Exsecratio]

I was wondering as it happens Dave, I tend to do a lot of burn detailing on the models I design and I did wonder if the timer function doesn't take into account speed up and slow down (the read ahead function)??

I tend to run burn details at 300 speed 8 to 10 power...

I'm gonna give it a go with just a cut model and see what it comes up with

best wishes

D2

[kadeR]

it only cames with an "pack laser" with the driver ***camV2.2 and the addon for corel and autocad. the machine is an PC 1390 KII from Perezcamps.

Abby what is an pci type? =X

[kadeR]

the pack comes with an usbcamV2.2 driver and the software is an zhbcd plugin for corel and autocad.