The wire from relay 6 "TO ROUTER" goes to the router, but where is the other router cable connection going to? It should not be the green GROUND wire below it in your drawing. Shouldn't it be to the black wire labeled Neutral? (110 VAC RETURN)
Relay #5 lower left pin (blue wire) goes to the terminal strip, but goes nowhere else. Shouldn't that wire go to the other blue wires for that pin on the other relays? Put a jumper wire from the lower terminal strip to the lower terminal of the upper terminal strip to make that connection?
I think you will need a filter capacitor of some sort on the 24vdc output of the bridge rectifier to smooth the 120hz ripple.
CarveOne
http://www.carveonecncwoodcraft.com