[sagreen]

I have a new grizzly SX3 and am starting the conversion with CNCFusion parts. Before I bought the parts, I was doing a ton of research and stubled across a thread where a guy had built an Amazing CNC mill out of a SX3. He had made his own bellows, chip tray, custom limit switch covers etc. It was the best one that I had seen and now I have lost the thread.

Anyone know which thread that would have been?

Thanks.
Scott...

[LUCKY13]

You might try looking in the subsection of this forum. Look at the top of the page where your thread is they have a X3 section so the thread may have been in there, or moved in to there if it was posted before that section was added.


For some reason I am thinking I remember the thread your talking about, but then again there was so many X3 threads for a while it could be any of many.


Jess

[LUCKY13]

BTW I think I found the one your talking about.

http://www.cnczone.com/forums/x3_sx3...p_snapamp.html


Maybe this is it.

Jess