[mousongie]

Hi to all,

Im working on a cnc lathe Kia Turn 31 with a Fanuc OT control.

The machine is having a Tape mode. Can someone who did use that mchine helps me with the correct dnc parameters( baud, parity, even......) . I try to send or receive a program ,but nothing works.

Thanks in advance.

[Sergiogc]

Parameters screen
Par 000 ISO = 1 For FANUC Device.
Par 20 I/O = 1
Make sure that par 0100 bit 3, NCR =1
Par. 111= 1000001
Par. 112= device num.- 0 (rs232)
Par. 113 baudrate.- 10=4800,11=9600
MAke sure of these parametres are OK..but the sftware you are using in you PC must has the same baudrate configuration,bit, etc and the port of your PC as welll.I hope this helps...

[alexfanuc]

Hi to all,

Im working on a cnc lathe Kia Turn 31 with a Fanuc OT control.

The machine is having a Tape mode. Can someone who did use that mchine helps me with the correct dnc parameters( baud, parity, even......) . I try to send or receive a program ,but nothing works.

Thanks in advance.

If the control is 0T then check parameters (X= don´t care)
2= XXXXXXX1
38=X1XXXXXX
552= 10 (10 means 4800)

Can you upload and download programs?
If you change to "tape" mode do you see any diagnostic change?

It is important to see if the control is a 0T (A, B, C) or a 0iT because the parameters are different and the diagnostics are different. If it is a 0iT then use the parameters shown by Sergio.
Regards
Alex

[mousongie]

Hello guys!

Thanks for your quick intervention. The control is OT, and so far i cant either receive or send a program to the computer or vice versa. I will try the above settings tomorrow and i will let you know the outcome. Big thanks to Sergiogc and alexfanuc .