We have a Mori Seiki MV35/35. yasnac mx1 control
Here is the problem : It zeros out fine, jogs, manual is fine, no alarms.
If you command it in either MDI or Auto mode as soon as cycle start is pressed it just shows alm flashing on the bottom of the crt. No alarms on either the message or alarm page.It is the same for any m,s,t, or g code, it is same result. Only thing obvious is the contactor for the servos power supply drops out and diagnostic 1218.0 is high ( alm). We have done a regeneration of the memory, no difference. Any suggestions would be appreciated greatly.