[ttm]

I am having a heck of a time setting up this system
does anyone have screen shots of their pins/ports input settings for my setup, I have looked in the install guide and it only give some of them
My setup

CandCNC PlaspakIII (purchased used),
esp controller, mp3000 w/ubob card rev6b (ubobII)
DTHC,
Hypertherm powermax 1000GS (w/machine torch)

I am stuck - config/ports&pins/input signals

[plain ol Bill]

Join the CandCNC group on Yahoo. Tom may find your post here and answer to help you but if you join there and post Tom (and other helpful folks) will jump in to get you up and running.

[ttm]

Join the CandCNC group on Yahoo. Tom may find your post here and answer to help you but if you join there and post Tom (and other helpful folks) will jump in to get you up and running.

I did, I'm not quite understanding it all, and he is a pretty busy guy and has put some time in trying to help me out, I did not buy it new either.

I was hoping someone here might have the same setup, if I could see he right settings I might start putting it together how it all works together, or at least get the differences in the ubob versions,