Good day.
I have a VMX50 machine and it had a problem with the hard drive. After repairing and restoring the system from a backup, problems arose.
An error occurred during the first boot: configuration not found. I loaded the configuration from an existing floppy disk, after which the system booted. But almost all the buttons on the control panel do not work. At the same time, on the Kanbas board, when these buttons are pressed, a green LED lights up, indicating data transfer. Only the keyboard buttons work.
While researching the problem, I discovered two config folders on drive C:. Removing one of them again results in a missing configuration error. After booting from the floppy disk, the second folder appears again.
To what extent can this be related?
Ultimax 4 system, version 2.37
Also during diagnostics and repairs the following operations were performed:
1. The processor board was removed and the BIOS battery was replaced. Bios has been reset.
2. The video card board was removed. The cooler did not work on it, it was repaired.
3. CANBUS was removed. But no problems were found there.
To perform all this diagnostics, the computer was removed from the machine.
Is it possible that I did something else wrong during or after the diagnosis?
Please help.