587,143 active members*
5,524 visitors online*
Register for free
Login

Thread: Bridgeport CNC Series II Boss 6 is Dead!

Results 1 to 20 of 21

Hybrid View

  1. 05-16-2016, 01:06 PM #1
    machintek
    machintek is offline Moderator
    Join Date
    Nov 2004
    Posts
    3028

    Re: Bridgeport CNC Series II Boss 6 is Dead!

    If you have no display, I would check the output of the logic power supply. Also make sure all boards are seated correctly and facing in the same direction.
    The display board is very static sensitive but if you did not remove it, either is is a power issue or signal issue.

    George
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  2. 06-18-2016, 09:04 AM #2
    aBigSAM
    aBigSAM is offline Junior Member
    Join Date
    May 2016
    Posts
    5
    Thanks machintek, here's an update. I have got the readout back working but still have the 000 60006 error. Swapped every board (LS1-11, RCK, ERS, and XDI) with the box of extras that came with the machine. Got the error message to change to 060 00007 when I swapped the XDI board. No other board swap changed anything except the XDI. (The LS1-11 swap caused the readout to go back out again so I put the original one back in) Power seems to be perfect, both on the unregulated side as well as the regulated side. Both within tolerances. I'm not sure what signal issue I should be looking for.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Series 1 BOSS 5 X Axis Dead, still dead after new transistors
    By keebler303 in forum Bridgeport / Hardinge Mills
    Replies: 3
    Last Post: 02-01-2014, 04:27 PM
  2. Bridgeport Boss 6 Series II
    By grigsby in forum Bridgeport / Hardinge Mills
    Replies: 5
    Last Post: 09-29-2012, 03:37 AM
  3. Bridgeport Series 1 cnc Boss 5
    By pyroboby in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 09-01-2012, 11:44 PM
  4. Series I Boss 5, All axis dead
    By timprebleco in forum Bridgeport / Hardinge Mills
    Replies: 8
    Last Post: 01-31-2009, 06:49 PM
  5. Bridgeport Series I Boss 4
    By millwrightguy in forum Bridgeport / Hardinge Mills
    Replies: 6
    Last Post: 06-28-2007, 02:07 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules