[EXLASer]

We join in this thread to Give Suggestion and Help to other machine user here>
Need Help!- CO2 laser cutting white acrylic- burns
http://www.cnczone.com/forums/laser_..._acrylic-.html

Regards/Mike

[EXLASer]

http://www.cnczone.com/forums/produc...d_edition.html
Regards/Mike

[EXLASer]

We join in this thread to Give Suggestion and Help to other machine user.
GWEIKE Power Supply PLEASE HELP http://www.cnczone.com/forums/laser_...ease_help.html

[yasam2002]

Problem of laser power which is not the same on the whole table, it can cut with the same power till the center of the table but when going far to the extreme right of the table at the top or at the bottom it can not cut i have checked the table it is weel leveled .
what do you suggest ?
the table is 900mm*600mm and the laser tube is Reci 80w used for only 2 hours.

[EXLASer]

Yes ,you are right . The table is not on the same level that you need to adjusting the table untile each conner and the center are on the same leave .
Mary from XYZ Machinery
[email protected]