I am using mc x5 to program. I have not done much programming on lathes let alone dual turret. I am more familiar with fanuc controls and haas.
the problem is the post...ex...
G00 T0303
G97 S2000 M03 P20
G00 X17.5516 Z20. M08
Z8.18 M145
G01 Z8.08 F.014
X16.4962
Z8.18
G00 X16.9154
G01 Z8.08
G03 X17.388 Z7.8437 L.2363
G01 Z7.807
G03 X16.3816 Z7.3038 L.5032
G01 X16.172
G02 X15.9287 Z7.1923 L.1221
G01 X15.8695 Z6.8539
G02 X15.8971 Z6.7261 L.3326
G03 X15.3888 Z6.113 L.5183
G01 X14.9132 Z5.9883 F.02
G02 X14.568 Z5.7028 L.3223
G01 Z4.0832
G02 X14.6954 Z3.9082 L.2722
G01 X14.8954
G00 X18.5
Z20.
X100. Z100.
G97 S1000 M09 M144 P9000
M101
G04 F1.5
M102 P9700
G00T0606
G04 F1.5 P9800
G97 S50 P9801
G04 F1.0 P9802
M19 P9803
M91 P9900
I Understand most of it but am not familiar with the "P" to a mill guy that is usually the circle jerk loops on like a vf5
any help would be nice...thank you