[okabum]

Hello

Some weeks ago, I send mail to syil requesting info for configure EMC. No answer given, so perhaps I´ll receive here.

I need this info for configuration, I have purchased my machine and cannot use correctly because mach3 is a poor program due to windows problems.

DRIVER INFORMATION IN NS OR MICROSECONDS
Step time
Step Space
Direction Hold
Direction Setup

Base period maximum jitter

Pin configuration I assume will be correct on x5+ manual so I´ll obvious it.

X AXIS CONFIGURATION

Motor steps per revolution
Driver microstepping
Leadscrew pitch mm/rev
Maximun velocity mm/s
Maximum Acceleration mm/s2

Y AXIS CONFIGURATION

Motor steps per revolution
Driver microstepping
Leadscrew pitch mm/rev
Maximun velocity mm/s
Maximum Acceleration mm/s2

Z AXIS CONFIGURATION

Motor steps per revolution
Driver microstepping
Leadscrew pitch mm/rev
Maximun velocity mm/s
Maximum Acceleration mm/s2

A AXIS CONFIGURATION

Motor steps per revolution
Driver microstepping
Leadscrew pitch mm/rev
Maximun velocity mm/s
Maximum Acceleration mm/s2

SPINDLE CONFIGURATION

PWM Rate Hz


Thanks for your attention.
Cheers
Pablo

[danielmb]

would be great to have that info.

Daniel
Santiago Chile

[neilw20]

Windows Problems.
Use a desktop. Not a laptop, or just load Mach3 anyway, and all the information is in the configuration.
Laptops won't work properly due to the battery saving inbuilt features using resources that actually make Mach3 work in a timely manner.

Don't blame Mach3. Blame the laptop.