[Pplug]

Hey guys,
We have an ILS-3 Intelligent Laser System made in 2001. I have an old laptop with some drivers loaded on it but we encounter periodic problems with outputting jobs to the engraver. I was wondering if anybody has expierience with this laser engraver and has updates for the drivers or firmware. The ltt website is virtually worthless and looks incomplete. I don't think it has been updated in the past 5 years!

Any help on this would be greatly appreciated!

Thanks all!

[Pplug]

I'm still looking for this stuff! Anybody have anything? Btw.. The engraver works pretty good when windows or the drivers I have let it!

[Pplug]

This is a 10x9" engraving in birch ply. The photo was a low contrast cell phone pict! It was payed out in corel draw. The problem with the drivers is that it won't engrave and cut in the same job. I had to print two separate jobs to get each on the same board.

[hyperion61]

I was able to get drivers for the a client of mine for this machine from LTT. Email [email protected] with your request.