[positiverake]

Anybody have a operator/programming manual for a Fanuc 0M ?

[Al_The_Man]

PM an email address.
Al.

[yours_prabhat]

send a mail requesting for manual (mention manual type = prog/opr/maint/electrical) on [email protected] .regards

[KeithMc]

I have that control on an old 1980's vintage Okuma Howa mill, with English (vs Metric) lead screws, a paper tape reader, etc.

We finally got it running, so I now mainly need
A) the Programming Manual (see next), and
B) enough electrical and protocol data on the Paper Tape reader & interface, to let me hack up some sort of a direct data link in place of it.

For Programming, I seek at a minimum a FULL list of the supported G&M codes, their associated letter parameter definitions, and how you properly do things like define the G02 arcs (half circle? quarter? etc), define variables, do subroutines and loops, etc.

I've sent direct PMs to both Al and Prabhat about the Programming manual (but forgot to mention the PTR). If anyone else has that manual (or PTR data), please contact me directly or post here.

Thanks!
- Keith Mc.