Hail mighty superbrains of machining!!
My problem is the following:
I want to make my machine (okuma MSV4020 with an OKUMA OSP-U10M control) able to dripfeed the programs from pc, but the manuals of the machine are very hard to understand..(especially if the communication parameters are not in it, like in my case (
so please somebody who have routine in DNC-B write a full description about the settings witch I have to configure on the machine and pc, I will also need a communication software (I already have NClink but if it is not acceptable) and a step by step guide for setup and establishing connection and starting program via DNC-B...