machine :Okuma Multus B400W U OSP-P200L
error: 1774-01 Alarm A Toucsetter aside 4
In middle of machining process control gives that alarm and machine stops.
Sometimes, not always.
If i have understand correct machine thinks that touch setter is not at safe position (limit switch must be off for a while). However when checked from diagnostic, it seems to work ok.
I already take out lower plate from bottom of setter. There is little circuit and everything was clean. So limit switch must be under upper plate ?
has anyone never adjust those limits & are limits there ? I have to take whole setter out because chuck is so close.