[bobacker]

We have just installed an old Rye router with a Bosch CC100 controller, but have no manual or instructions. It was working at the previous owners factory, but we are not able to get it running. There is an "axis error" flagging on and an error code 50 showing and also a error code 35 "no machine reierence, send axes to reference" shows when we try to manually operate an axis. Any help would be welcome.

[dougdownunder]

Hi, I used to opperate a wadkin Router with a Bosch CC100 control panel, it's been 4 years since last using it, but if I remember corectly there is an ( over-ride Key on the control panel) that you turn to be able to operate manualy, you should then be able to turn the jog wheel to clear the axis error. Does the screen tell you which axis the error is in?

[dougdownunder]

Hi, Also try checking that all of your limit switches are clear of anything that might have tripped them!