[Slick27]

Machine was running fine Thursday. Yesterday machine fires but no monitor or
the nc side of the control does not come up. Machine can home,spindle works,
turret works but no screen,fapt, or nc.
Monitor just replaced within a year,there is power at the monitor but no signal.
Both monitor and pc board for front keys for fapt are seperate entities.

Does anyone have a complete schematic of this lathes electonics?

Any ideas???

[DouglasR]

I had a Victor lathe with a Fanuc 10T-F fapt control and it did the same thing. Inside the control pendent is a small video driver board next to the CRT. Check it, as it may be bad.

[abid iqbal]

hello sir ihave cnc lathe EMI TOURCH with fanuc 3t CONTROLL INEED PARAMETER LIST OF THIS MACHINE IF ANY BODY HAVE PLEASE SEND ME PARAMETER LIST [email protected]
THANKS
ABID IQBAL

[abid iqbal]

HELLO =I HAVE CNC 3T FANUC MADE EMI TORCH PROBLUM X AXIS AND Z AXIS ARE READY BUT TURRET DRIVE AND TOOL DRIVE ARE NOT READY .MACHINE DONT SHOW ANY ALARM X-Z MOVES ONLY ON JOG MODE ALL MODES ARE SLECTED .NO MOVEMENT WITH HAND WHEEL .SPINDLE NOT RUN ON MDI COMMAND .I AM NOT SURE ITS PARAMETERS ARE CORRECT.IF ANY BODEY KNOW PLEASE HELP ME IF SOME ONE HAVE ITS PARAMETER PLEASE MAIL ME AT MY [email protected]
thanks
ABID IQBAL