[peakmachining]

I have a Takisawa TS 15 lathe with a fanuc 6t control Spindle turns on in the "handle mode" but not always in Auto or MDI mode. I thought it was my G50 G96 G97 programming, but it will work for a while and then juts stop working. One time is was running good all day until I hit e stop then it wouldn't work after that. Any ideas?

[cncsolutios]

I have a Takisawa TS 15 lathe with a fanuc 6t control Spindle turns on in the "handle mode" but not always in Auto or MDI mode. I thought it was my G50 G96 G97 programming, but it will work for a while and then juts stop working. One time is was running good all day until I hit e stop then it wouldn't work after that. Any ideas?

Kindly check spindle drive main contactor.
If possible please send me nc and pc parameter of same machine. due to pc parameter spindle is not working in our machine.
Thanks
Devender