[IMIautoDesign]

im a metal fabricator looking to stop cutting all my brackets out by hand.
we use 1/4inch 8X4 plate and 1/8inch plate of the same dimensions, so we are looking at building a plasma table. anybody willing to help me out with any and all good information would be my new hero. thanx for yalls help in advance.

[RICHARD ZASTROW]

You could purchase 1/4" X 4" flat bars of HRS or CRS. Then have them sheared to 8" lengths. Less mess and good edges.

Dick Z

[IMIautoDesign]

You could purchase 1/4" X 4" flat bars of HRS or CRS. Then have them sheared to 8" lengths. Less mess and good edges.

Dick Z

appologies i meant 8'x4'

[IMIautoDesign]

anybody have any advice on getting plans or what type of pieces i should use in order cut this material. what kind of consideration are there to take in to account when picking rail type, motor strength, etc.

[jharvey407]

anybody have any advice on getting plans or what type of pieces i should use in order cut this material. what kind of consideration are there to take in to account when picking rail type, motor strength, etc.

Take a look at the MechMate. It might be a good solution for you. I think I've read that they have been built with plasma cutting heads.

MechMate CNC Router - Build your own with our detailed plans

[IMIautoDesign]

thanx for the tip but im really looking more at good plans or guides to building my own with parts lists. advice on what type of drive system i should use and what types of motors i should use those are things im looking to find out so if you guys could point me in the right direction that would be much appreciate it.