Hi Rivethead, CSP is a typo, It should have been CSM ( Custom Servo Motors) This is an electronically shifted 3 speed motor. with a max 4500 RPM.
On your machine you have to swap the belt for the different speed ranges and set the spindle range parameter, (1 =low, 2= med 3= high)

Your P1D can be run on single phase. Wire your 220vac (10 GA multi strand wire with a 30 A breaker.) to L1 and L3 and jumper either L1 or L3 to L2. don't forget the ground wire.
Check the incoming voltage, 220, 230 240 or ?? and check the 220 to 110 transformer, below the disconnect switch and match the incoming voltage to the closest tap on the transformer.

sportybob