[handy223]

Hello everyone,

I have a 2007 Bridgeport XR1000 that throws up a 2063 alarm message "Air Pressure too Low !!"

The air pressure is fine and I have checked the low pressure switch where the air is connected to the machine and it is operating properly.

Is there another pressure switch hidden somewhere ??

I don't hear any abnormal hissing as though an air line might have disconnected and the manual I have doesn't show the ladder or give the ladder designation for it.

I tried calling my local distributor, but they only want to send someone out to check it.

I went through the electrical schematics and found the pressure switch 12S1 is X1.7, But when I have checked the diagnostics page X1.7 is not on.

Is there another signal to check ?

[handy223]

There is another air pressure switch along side of the spindle that needed to be adjusted.

Hell of a way to find out there's no tech support from Gosiger unless you pay.