Have a Matsuura MC510VG, Yasnac control that I need help with tool change recovery.

Operator hit reset at end of tc cycle. No alarms, but the end condition was tool in spindle and magazine pocket in down position. (30 pkt magazine)

Raised magazine pocket and verified lock pin switch working and magazine rotates properly. Verified tc arm in home position and moves freely using manual atc drive shaft. Tool releases from spindle.

Using diagnostics guide from the book it references that it is "waiting for the completion of magazine lock pin 'out'". Looking at the diagnostics, everything appears to be satisfied but I am unable to change tools or start spindle. I even tried shutting down completely but no change.

Any suggestions welcome!