[Vegabond]

Hello.

I buy a TB6560 card on e-bay ( 4 Axis TB6560 CNC Stepper Motor Driver Board Controller - eBay (item 280580580507 end time Feb-23-11 02:02:04 PST) ) and burn it up second time..

Everything is ok, but when i run motor in mach 3 the chip is burning and some lovely smoke get up in the air..

Here is the motors i run. http://www.kelinginc.net/KL23H2100-30-4B.pdf

Can i burn up the card if i set the wires from the motor in wrong place?

I want a Gecko 540 drive, because i heard that is life time garranty on them, is this true?


Some help please...


Greetings from Robert.

[eaglezsoar]

What is the voltage of your power supply?

[Vegabond]

First time i try, it was 32 volt. Second time (today) we try 24 volt....

Robert.

[eaglezsoar]

It should work at 32 or 24v.
Yes, you can burn up the card if the wires are hooked up improperly but you only have
the 4 wires from the motor, it shouldn't be too hard to hook it up properly.
The Gecko 540 is a nice unit and is what I use but it does not have a lifetime warranty.
The warranty is one year I believe, but Gecko has been known to repair out of warranty
depending on what's wrong but they are not obligated to do so.
There are a lot of people on this board running the TB6560, I don't know why they are not responding. Search this board for TB6560 and you will find lots of information about
the card.