I'm interested in any experience, products and advise folks have regarding tapping small (2-56, mostly 4-40, 8-32) holes in primarily brass and aluminum. I mostly tap through holes up to 5/8" and blind holes 3/8" deep.
regards,
Michael
I'm interested in any experience, products and advise folks have regarding tapping small (2-56, mostly 4-40, 8-32) holes in primarily brass and aluminum. I mostly tap through holes up to 5/8" and blind holes 3/8" deep.
regards,
Michael
Reelsmith, Angling Historian, and Author of "The Reelsmith's Primer"
www.EclecticAngler.com | www.ReelLinesPress.com