Minimill Toolchanger Problem
I have a 2006 Minimill with a 10 tool umbrella changer. I got an alarm 127 - No Turret Mark about 2 weeks ago. I powered it down and restarted it, then it worked fine. Last week it came up again with the same result. On Thurs it did it again, but now it will not work at all. Alarm 115 - Turret Rotate Fault comes up when it tries to reset the indexer. It will not let me home any axis, and therefore I can not run any parts.
All I need for now is one tool to do some engraving, so even being able to bypass the changer would be fine until I can get it looked at properly.
I can't even get the covers off the changer to get a look at any sensor that may be boogered up.
Any help or suggestions would be welcome and appreciated.
Apparently I don't know anything, so please verify my suggestions with my wife.