We had some students break the end off of the gib on our Bridgeport EZ Trac mill. The soft limits were not set properly and the servos overran the end of the table....
Anyway, the X axis gib is broken. The tip that keeps it from wedging all the way into the ways snapped off. Does anyone know how one goes about finding a new/used gib? We are considering repairing the old one with silver solder, but would rather replace it if we can.
Thanks
Thread: Bridgeport gib replacement
Results 1 to 2 of 2
-
02-01-2011, 04:01 PM #1
Registered
- Join Date
- Feb 2009
- Posts
- 7
Bridgeport gib replacement
-
02-01-2011, 04:20 PM #2
Junior Member
- Join Date
- Jul 2010
- Posts
- 369
Go here and you can find all the info you need.
Bridgeport Knee Mill Repair Parts from Hardinge
Good Luck~!
Reply With QuoteSimilar Threads
-
Bridgeport Explorer (V2XT, DX-32) Motherboard Replacement
By FugginZukin in forum Bridgeport / Hardinge MillsReplies: 9Last Post: 01-10-2011, 08:15 PM -
Bridgeport EZ-TRAK LCD replacement Monitor
By RADAPG1 in forum News AnnouncementsReplies: 0Last Post: 10-26-2009, 03:42 PM -
Bridgeport Series 1 steppers - replacement
By CozyGirrrl in forum Bridgeport / Hardinge MillsReplies: 19Last Post: 08-24-2009, 07:06 PM -
Bridgeport servo motor repair or replacement
By greeder88 in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 02-22-2008, 10:32 PM -
bridgeport spindle motor replacement 1phase
By plascom in forum Bridgeport / Hardinge MillsReplies: 16Last Post: 02-25-2005, 03:15 PM
Posting Permissions
