Hello: I have a handwheel on my mill, pulse wheel I guess. It makes noise at times, like a frying/squeeling sound. If you move the wheel a bit it changes or goes away. Is this normal? Its a AB unit if that helps.
Thread: Noise from a hpg, normal?
Results 1 to 3 of 3
-
10-25-2010, 05:51 AM #1
Registered
- Join Date
- Sep 2010
- Posts
- 145
Noise from a hpg, normal?
-
10-26-2010, 01:08 PM #2
Registered
- Join Date
- Jan 2006
- Posts
- 738
Where is the noise coming from? The hand wheel? Drive motors? Power board? You may have a very small following error causing a low drive level to the motor. With PWM drive, you may be hearing the pulses (high frequency) trying to correct the error. Moving the wheel, may be correcting the error causing the drive to stop trying to move to correct it.
Steve
-
10-26-2010, 04:14 PM #3
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24223
Normally there is very low current through a H.W. so there should be no electrical noise from the unit itself?
As Steve mentioned, it sounds more like the servo making the noise?
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Similar Threads
-
Need to know if this is normal (DX-32)
By EFI-Unlimited in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 10-06-2010, 09:11 PM -
is this normal?
By 15mgtar in forum Stepper Motors / DrivesReplies: 2Last Post: 04-01-2010, 12:01 AM -
Gremlin or Normal?
By Mr.Chips in forum Gecko DrivesReplies: 9Last Post: 01-20-2010, 02:12 AM -
Lots of crunching noise from Z axis ballnut. Normal?
By alexccmeister in forum Benchtop MachinesReplies: 21Last Post: 08-27-2008, 02:05 AM -
This is NOT a normal noise
By Dancy in forum FanucReplies: 11Last Post: 05-24-2008, 10:26 PM
Posting Permissions
