I set my surface a 0 and I set my safe z at .125, but when I post the gcode and open in mach3, instead of seeing a rapid I see a tool path.
I checked the gcode and it reads G0 Z.080.
I edited the gcode right from Mach3 and changed the line to G0 Z.125 and saved. I then regenerated the tool path and the line was still blue and not a red dotted line.
The work piece has a total of 5 pockets , the pockets all have the same attributes and they all work correctly except for this one.
Has anybody else ever had this problem?