586,461 active members*
5,489 visitors online*
Register for free
Login
IndustryArena Forum > Mechanical Engineering > Linear and Rotary Motion > Amount of axis in rotary head of OMAX Tilt-A-Jet

Thread: Amount of axis in rotary head of OMAX Tilt-A-Jet

Results 1 to 3 of 3
  1. 08-04-2010, 08:39 AM #1
    Mr Helmut
    Mr Helmut is offline Registered
    Join Date
    Aug 2010
    Posts
    0

    Question Amount of axis in rotary head of OMAX Tilt-A-Jet

    Is ther 4 axsis in the rotary head as I have showed in my picture? Lock´s so in the movie. Strange...

    [nomedia="http://www.youtube.com/watch?v=CXDFYRCWUJc"]YouTube- OMAX Tilt-A-Jet Cutting Head Accessory[/nomedia]
    Attached Thumbnails Attached Thumbnails Tilt-A-jet_paint.JPG  
    Reply With Quote Reply With Quote
  2. 09-28-2010, 09:06 PM #2
    adambrum
    adambrum is offline Registered
    Join Date
    Aug 2010
    Posts
    7
    Yep thats a 4th axis for taper compensation, not sure how far it goes over but i know on other machines its about 8 degrees for taper compensation or 60 degrees if you go 5-axis
    Reply With Quote Reply With Quote
  3. 08-24-2012, 02:24 AM #3
    Bryden
    Bryden is offline Registered
    Join Date
    Mar 2010
    Posts
    0
    We have one of those adambrum is right, its just for taper compensation, but can tilt up to 9 degrees if you want it to
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Rotary head development 3 axis -> 5 axis
    By Mr Helmut in forum Mechanical Calculations/Engineering Design
    Replies: 1
    Last Post: 08-03-2010, 11:26 PM
  2. OMAX Files
    By steeler1933 in forum Waterjet General Topics
    Replies: 6
    Last Post: 05-04-2010, 03:47 PM
  3. Rotary table or deviding head
    By JpBinc in forum Linear and Rotary Motion
    Replies: 4
    Last Post: 12-16-2008, 05:26 AM
  4. rotary table or dividing head
    By JpBinc in forum MetalWork Discussion
    Replies: 0
    Last Post: 12-14-2008, 03:00 PM
  5. Rotary head slack
    By Bugster in forum Syil Products
    Replies: 5
    Last Post: 08-20-2008, 05:53 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules