Aloha All,
I'm getting close with my X2 hoss conversion. I have the G540 and Mach3. I am generating gcode with vectric cut2d. I have made a simple circular pocket in a rectangular piece of stock. When I load the gcode with the 540B
.xml I get the error message "Radius to end of arc differs from radius to startline ###". Also, if get no graphic toolpath in the toolpath display.
When I load the mach3mill profile and load this gcode, it loads fine and there is a toolpath graphic. The only variable that I can isolate between what works and what doesen't is which .xml profile I load with the mach3loader at mach3 startup.
I was hoping that this is an error message that someone has seen before and there might be a simple fix or tweak. Any thoughts?
Is there a different place that I might post this question?
I can attach or email the gcode .txt if anyone is interested.
Thanks! -4ist