I am trying to get a post for Visual Mill 6 polished up for the 5020M control and am having trouble with G2/G3 arcs. I have tried a couple of different settings but am not getting anywhere.
My listed Output options are:
1) I,J,K and radius
2) I,J, K only
3) Radius only
4) Output Values only when different
5) Use -R for CW arcs
Arc Center (I,J,K) options are listed as:
1) Absolute
2) Vector from Center to Start
3) Vector from Start to Center
4 Unsigned Vector from Start to Center
Anyone have any ideas on this?
Results 1 to 3 of 3
-
06-16-2010, 06:02 PM #1
Registered
- Join Date
- Feb 2010
- Posts
- 0
Error 453 Alarm B Data word: radius 1 on 5020M control
-
06-17-2010, 01:26 AM #2
Registered
- Join Date
- Jun 2005
- Posts
- 142
I'd try I,J and K only, with Vector from Start to Centre
-
06-17-2010, 02:09 PM #3
Registered
- Join Date
- Apr 2009
- Posts
- 1262
I agree on the start to center. The control is capable of I,J,K and Radius, so that's what I use in my post setup on GibbsCam.
Best regards,
Reply With QuoteSimilar Threads
-
tl-2 program integrity error and program data error alarm #'s 212 250 need help
By CNChelp in forum Haas MillsReplies: 12Last Post: 03-15-2010, 02:19 AM -
Error 414 Z axis error detect- servo alarm
By andywids in forum FanucReplies: 0Last Post: 07-09-2009, 04:33 PM -
Error 414 Z-axis error detect servo alarm
By andywids in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 07-09-2009, 03:56 PM -
AlibreCAM and Mach3 K-Word Error
By cjjonesarmory in forum Mach MillReplies: 1Last Post: 07-02-2009, 06:35 PM -
HAAS Radius error
By QMI2007 in forum Haas MillsReplies: 10Last Post: 02-07-2008, 05:48 PM
Posting Permissions
