Hello, Mr. Kretov I did the setting in Mach3 and seems now is working properly, but I have to say what it is output pin for the PWM, I can not leave without informing a particular pin is not the program will not know which pin should send the signal. I can not disable all relays because I'm using a breakout with my controllers for wrapping other functions too. I'm only doing bench testing because, I'm hoping to get some components that I ordered to finish of mount my ESC for brushed motor, this link - http://norbique.rchomepage.com/esc/. Thanks again for help me.
The setup was so:
Results 1 to 20 of 35
Threaded View
-
12-08-2012, 04:13 PM #9
Registered
- Join Date
- Mar 2005
- Posts
- 29
Reply With QuoteSimilar Threads
-
RC Brushless motor controller for Mach3 / EMC2
By LOGICNC.COM in forum News AnnouncementsReplies: 1Last Post: 05-09-2014, 02:47 PM -
Brushless motor as a spindle ... And controll it with mach3
By lampadas in forum Spindles / VFDReplies: 2Last Post: 03-26-2014, 03:15 AM -
Robotic Arm and Mach3 interface
By Bow Hunter in forum Machines running Mach SoftwareReplies: 1Last Post: 10-10-2012, 07:02 PM -
Encoder interface for Mach3
By ishman in forum Mach Software (ArtSoft software)Replies: 3Last Post: 04-18-2012, 05:19 PM -
Project! Haas Vector Drive replacement, MOCON board / Brushless Servo Amp interface
By marvinmfg in forum Haas MillsReplies: 12Last Post: 07-11-2010, 03:04 AM
Posting Permissions
