Hello Kretov

i have burned a pic12f629 with your hex file. I used microbrn and i have to say that i have never burned a pic or other processor before. I get a message saying this" The oscal value should be in the form of a RETLW instruction [34xx] currently [3fxx] i build the pcb after your instructions, but i have some problems. When i Mount the pcb to 5v + and - from the supply that feeds all the drivers, and signal on pin 14. Then the led is not on. if i try to take a new power supply and only connect the 5v+ and - (no signal) then the led is rapid flashing in different frequenses
I do not have any ocilloscope so i can´t check the signal from pin 14 on the breakout board. If i messure the voltage the signal pin is 0v.
I hope you can help me out....