Can anyone tell me how to stop my Techno 4896 from sending the tool to Z zero before it starts to run the G code? It is unsettling. What if my Z zero is not at the top of my part? The movement is not in the G code it is something the machine is doing before it even turns the spindle on.
Thread: Z touch off before start
Results 1 to 3 of 3
-
05-26-2010, 09:49 PM #1
Registered
- Join Date
- Feb 2009
- Posts
- 7
Z touch off before start
-
05-26-2010, 10:26 PM #2
Registered
- Join Date
- May 2009
- Posts
- 281
setup / advanced / software switches / drop menu window towards the bottom of the list, set it to do not move to origin before start.
then test it so you know what it's going to do.
-
05-27-2010, 02:21 PM #3
Registered
- Join Date
- Feb 2009
- Posts
- 7
Thanks, That was simple. I looked for a menu like that for an hour or so. Don't know why I couldn't see it. Target fixation?
Reply With QuoteSimilar Threads
-
Disadvantages of 2 start vs. 5 start?
By Biff in forum DIY CNC Router Table MachinesReplies: 8Last Post: 05-22-2010, 10:42 PM -
One Touch IGF-L
By ProToZyKo in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 01-15-2010, 05:53 PM -
Arrow 750 Failed to start when I Push start Bottom in fornt of control !
By mte.jalal in forum Cincinnati CNCReplies: 4Last Post: 01-06-2009, 05:20 PM -
one start or two start lead screw
By Pinhead in forum DIY CNC Router Table MachinesReplies: 5Last Post: 11-23-2008, 05:32 AM -
Single start vs double start ballscrew.
By darik in forum Linear and Rotary MotionReplies: 13Last Post: 03-22-2007, 01:53 AM
Posting Permissions
