Hello
I had the pleasure of working the other Saturday at my shop and would like to share what I accomplished
The list:
10 parts total (all from Cold Rolled Steel)
Four different prints
13 Tools to setup
3/8 spot
.205 drill
1/4-20 tap
.265 drill
5/16-18 tap
.313 drill
3/8-16 tap
.359 drill
.376 Ream
1/4 Carbide EM finisher
1/2 Carbide Rougher (Garr VRX)
1/2 Carbide EM Finisher
2" Face
11 different setups/programs
One mill setup/programmer/operator
Two 6 inch Vises (already set up)
All material precut
One Hurco VMX 42 with Ultimax 4 control
Six hours
I though it was a good day overall.
Just wanted to share.
glovebox20