Mazak QT-20N T1 Control
Had a run away on X when it was homing , then it lost para from sitting so long .
Changed X amp and Encoder
Changed TR board on DC
Changed LX power supply board just to make sure it 24v to the top boards on amps (got three green lights on drives but no red charge )
Put in para from STD copy
Finally got rid of al 128 but it seems to not be in ready state but no Alarms

Is there a ready CR not being made that I am not aware of ?
Could the SQ not be right and not make it in a ready state by pulling the CR
I do not have the relay lay out for board
This was a running machine then it got moved