I would like to know all the technical stuff about these. There is alot of jargon I don't know what it means or does. If someone could point me to a website that would be great. Thanks!!!
Greg
I would like to know all the technical stuff about these. There is alot of jargon I don't know what it means or does. If someone could point me to a website that would be great. Thanks!!!
Greg
If you do a search for all that hardware you want information on, go to as many of the manufacturers web site's as you can, as a lot have not only have theoretical information, a few have free software for designing your system, amplifiers & motor sizes etc.
a place to start would be www.electromate.com www.motionvillage.com www.motiononline.com, Do a search for incremental encoders and you should get a lot of encoder manuf. For specific questions, you can always ask here.
Also try and get manufacturers free catalogue's, many have a wealth of technical data.
Hope this helps.
Al
Thanks for the help Al!!!
Greg
GV71,
That is my businness, if you ever need questions asked I will be happy to help you any way I can, feel free to PM me with questions.
"A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't"
Greetings From Down Under
Dave Drain
Akela Australia Pty. Ltd.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)