Hi,
well bassically ya I'm quite new to all of this, usually i am able to figure it out myself when i come into problems, but im stuck on this one.
Im trying to get a file from autocad, to open in mastercam so i can create toolpaths and an .nc file
What i want to be able to do is take a .jpg file and engrave it onto a piece of wood. I have used corel draw to get the .jpg file to convert to an autocad file, but now im stuck in trying to get it onto mastercam
I thought that all i had to do was make the cad file a .dxf, then open mastercam>file>converters>then open a dxf file and it would bring it onto the mastercam screen. and well im doing htat, but then the mastercam screen stays black. all i am trying to change is a simple 2d box that i created, soo im wondering if that is the problem.
Im quite stuck here, any help would be greatly appriciated
thanks
Ed