587,890 active members*
2,942 visitors online*
Register for free
Login
IndustryArena Forum > Community Club House > Newcncer here need help on speeding up mach3

Thread: Newcncer here need help on speeding up mach3

Results 1 to 2 of 2
  1. 03-13-2012, 09:28 PM #1
    ozon
    ozon is offline Registered
    Join Date
    Feb 2012
    Posts
    0

    Newcncer here need help on speeding up mach3

    Need Help with mach3 pleases just getting into mach3 I created g code with cambam for 4x8 foot piece of sheet metal for plasma cutting no mater what I set the feed rate 100 to 2000 in cambam the g code runs very slow in mach3 it would take all dam day to cut 5 12x12inch parts out of one thin piece 4x8 sheet metal

    Note have no table yet just playing with the software g540 kit on its way

    Is it my g code programming with cambam

    or mach3 settings
    Reply With Quote Reply With Quote
  2. 03-13-2012, 11:45 PM #2
    ger21
    ger21 is offline Community Moderator
    Join Date
    Mar 2003
    Posts
    35538
    Increase the velocities of the axis in Mach3's motor tuning screens.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. speeding up my cnc machine?
    By Splinter120704 in forum DIY CNC Router Table Machines
    Replies: 8
    Last Post: 08-11-2012, 05:30 PM
  2. Speeding up feed speed
    By aquaveg in forum DIY CNC Router Table Machines
    Replies: 2
    Last Post: 02-01-2012, 06:14 AM
  3. Speeding Up Stepper Motor
    By herring_fish in forum Stepper Motors / Drives
    Replies: 14
    Last Post: 04-03-2011, 05:44 AM
  4. Speeding up Production Efficiency
    By webgeek in forum MetalWork Discussion
    Replies: 8
    Last Post: 01-17-2011, 03:48 PM
  5. speeding up X axis IPS
    By pminmo in forum DIY CNC Router Table Machines
    Replies: 12
    Last Post: 08-19-2004, 08:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules