[jimbo12d]

Hi, I lost the cd that came with my ebay controller and the .xml config file that was on there. I cannot get it configged on my own.

Does anyone have the xml handy for this controller:
CNC 4 axis Stepper motor Driver TB6560 INCLUDES EXTRAS | eBay

Thanks
Jim

[jalessi]

Jim,

See attached file for Mach3 configuration information.

Jeff...

[jimbo12d]

awesome thanks

[cd_edwards]

I am curious how you find that TB6560 controller. I've been thinking about ordering one, but the reviews I've been able to find are not so good on them. Any thoughts on them would be appreciated even if it's in a private PM.

[jimbo12d]

I have not had it long and used it for much. I just ran a couple test straight cuts on a keling 4530
CNC Router Keling Technology Inc

I have not had any problems yet, it pulls about 5 total amps no matter under load or locking torque. Everything sounds good

I have cut some aluminum and it had a clean finish.

Once I run some complex gcode I will give a more in depth review for sure, as no one has seemed to really review this machine