587,259 active members*
3,013 visitors online*
Register for free
Login

Thread: needing Yaskawa cpo7c board repair

Results 1 to 3 of 3
  1. 06-09-2010, 02:37 PM #1
    bowmaster
    bowmaster is offline Registered
    Join Date
    May 2010
    Posts
    0

    Smile needing Yaskawa cpo7c board repair

    I need a good place to get a Yaskawa jancocd-cpo7c board repaired, Yaskawa is to expencive for me and it is in a older Matsuura machine so I dont want to put alot of money in it. any advice appreciated.
    thx
    Reply With Quote Reply With Quote
  2. 06-16-2010, 11:04 PM #2
    bowmaster
    bowmaster is offline Registered
    Join Date
    May 2010
    Posts
    0
    Any recomendations for Board repairs?
    Reply With Quote Reply With Quote
  3. 01-21-2011, 10:18 PM #3
    beezerlm
    beezerlm is offline Registered
    Join Date
    Oct 2005
    Posts
    169
    Any Luck with this? I am looking for the same. When I power the machine up the screen says "NC mode" in small letters at the top left for just a few seconds then the screen is blank. RIP Yasnac MX2 :violin:
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Need repair or c/over siemens board.
    By arob in forum SIEMENS -> GENERAL
    Replies: 1
    Last Post: 06-30-2010, 02:03 PM
  2. Yaskawa CP07 Control Board
    By wiks in forum Want To Buy...Need help!
    Replies: 1
    Last Post: 11-05-2008, 03:21 PM
  3. BMC 40 Suppressor Board Repair
    By VintageOverland in forum HURCO
    Replies: 1
    Last Post: 02-11-2008, 03:24 PM
  4. KTL board repair????
    By mansuper in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 11-19-2006, 03:57 PM
  5. Circuit board repair
    By motordude in forum CNC Machine Related Electronics
    Replies: 2
    Last Post: 02-20-2004, 05:28 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules