Hi everyone, I have built two router tables so far and I can move both axis with my fingers with no resistance, but when I try to drive them with the motors it shudders and shakes and does not seem smooth at all.
Nema 23 180oz
Any ideas
Hi everyone, I have built two router tables so far and I can move both axis with my fingers with no resistance, but when I try to drive them with the motors it shudders and shakes and does not seem smooth at all.
Nema 23 180oz
Any ideas
Hey Andrew,
What control software are you using?
What is your velocity and acceleration and set at?
Cory