Hello, we have a problem with one of our GROB piercing machines. Last Friday we had an error number 5136 - FSSB: Number of amps is small. After opening the cabinet I seen a blinking cursor on one of our amplifiers. We rushed in a new card to slide into the ampifier and when we turned it one the blinking cursor was gone. Now the new problem is that there is an alarm tag flashing on the screen but when you go into alarm deatails or all paths there is nothing displayed. Also it seems as if the whole amplifier is not even being seen. WHat should we do here to get this machine going. We have a 30 i screen and the amplifier is a A06B 6127 H208.