plasma cnc table 4x8 working surface heavy duty built by a company in london ontario
3yrs old with hypertherm 1250 torch assembly hypertherm PHC unit for z axis lift (9 inch travel)
Machine is run by flashcut post processor also have sheetcam software for editting.
Comes with computer and consol ,omic sensor,downdraft under carriage with blower.
complete and working as demonstrated
[ame=http://www.youtube.com/watch?v=1rllgU-57Ho]cnc plasma hypertherm 1250 with phc lift 4x8 working surface - YouTube[/ame]
located in ontario
Results 1 to 2 of 2
-
08-14-2011, 03:08 PM #1
Member
- Join Date
- Oct 2007
- Posts
- 1027
after 3yrs we're letting the table go
-
08-19-2011, 06:29 PM #2
Member
- Join Date
- Oct 2007
- Posts
- 1027
asking price
we're asking 17.500.00 have a bit over 30 into it
Reply With QuoteSimilar Threads
-
Swiss style CNC machinist/setup person min.3yrs experience
By mctee in forum Canadian Club HouseReplies: 0Last Post: 08-30-2010, 03:50 PM -
open table vs closed-table gantry setups
By nicanor76 in forum DIY CNC Router Table MachinesReplies: 2Last Post: 04-21-2008, 06:35 PM -
XY table design basics, linear ways to table size ratio?
By Konstantin in forum Mechanical Calculations/Engineering DesignReplies: 0Last Post: 03-13-2007, 06:21 PM -
testing motors without letting the magic smoke out?
By Sporqster in forum XylotexReplies: 2Last Post: 08-09-2006, 09:07 PM
Posting Permissions
